Installation Instructions
Albany Oregon
541.619.8335
Return to Main Page
Austin Healey BN1-BJ7, MG TD/TF, MGA
1600 Turn Signal, XK120, Morgan, and Others
LED Tail Light or Turn Signal Set
  • There are 48 super bright LEDs per circuit board.  One board for park/stop light on
    each side of the car.
  • Available for positive or negative ground cars.  Also available with red or amber LEDs.
  • The circuit boards are reverse voltage and over voltage protected.  The LEDs are
    rated for 10,000 hours continuous use.
  • The LED array uses about 80% to 85% less current then the standard tail light bulb
    (#1156, #1157).
  • The LED circuit boards connect directly to the existing wiring harness including the
    ground wire.  This eliminates problems with poor ground connections through the
    standard bulb socket.
  • An updated turn signal flasher is usually required to allow LED turn signals to work
    properly.  Click here for more information.
  • These units do not require any modifications to the car other than removing the
    existing wires and bulb holder from the tail light housing and installing the new units.  
    Save the original parts if you want to return the tail lights to the original
    configuration.
LED Tail Lights Set (Negative Ground)
$172.00 + $8.00 Shipping In US
LED Tail Lights Set (Positive Ground)
$172.00 + $8.00 Shipping In US
LED Turn Signal Set (Negative Ground)
$172.00 + $8.00 Shipping In US
LED Turn Signal Set (Positive Ground)
$172.00 + $8.00 Shipping In US
Red LEDs
Amber LEDs